Lower Utility Bills
Lower Utility Bills | Tankless Water Heater Install | Plumbing | Harrogate
Harrogate homeowners are discovering how easy it is to shrink their energy bills with HEP’s lower-utility-bills plumbing solutions. Our expert crew delivers a seamless tankless water heater install that swaps out your old, power-hungry tank for a sleek, on-demand system. You’ll enjoy endless hot water, faster heat-up times, and up to 40% energy savings—all while reclaiming valuable space in your utility closet.
From upfront estimates to courteous clean-up, every step is handled by licensed technicians who live and work right here in Harrogate. We source top-rated equipment, back it with rock-solid warranties, and offer convenient financing so you can start saving today. Ready for hot water that pays for itself? Schedule your tankless upgrade with HEP and watch those utility bills drop.
FAQs
How can a tankless water heater lower my utility bills in Harrogate?
Tankless units heat water on demand instead of storing 40–50 gallons around the clock like a traditional cylinder. Because there is no standby heat loss, households typically save 20–40 % on annual gas or electric water-heating costs. In Harrogate’s moderate climate, the incoming water temperature is well within the efficiency range of most tankless models, so you’ll see the advertised savings year-round.
Is my home’s existing plumbing suitable for a tankless water heater installation?
Most Harrogate homes can be retrofitted. We inspect the incoming gas line (or electrical service) to confirm it can deliver the higher BTU or amperage a tankless unit demands during operation. We also verify flue venting, condensate drainage, and water-line sizing. If upgrades are required—such as a larger gas pipe or 240-V circuit—we’ll quote them up front so you know the full project cost.
What size tankless unit do I need for my household?
Sizing is based on total simultaneous hot-water demand measured in litres or gallons per minute (GPM) and the temperature rise between incoming cold water and your preferred hot-water set-point. We multiply the GPM of each fixture (shower, dishwasher, washing machine) likely to run at once, then match that figure to a unit capable of delivering the required flow at Harrogate’s average winter inlet temperature of about 9 °C (48 °F). For a typical three-bed, two-bath home, a 9–11 GPM gas unit or a 27-36 kW electric model is sufficient.
How long does installation take and will I be without water?
A straightforward replacement usually takes 4–6 hours. If we’re upgrading gas piping or electrical service, expect a full day. We schedule the work to keep downtime minimal—usually less than two hours without hot water. Cold-water service remains available the entire time, so basic household activities can continue.
What maintenance does a tankless system require to stay efficient?
Tankless heaters need an annual flush with white vinegar or a manufacturer-approved descaling solution to remove mineral build-up, which is common in Harrogate’s moderately hard water. The inlet filter should be checked and cleaned every 6–12 months. These tasks take about 45 minutes and can be done by the homeowner or as part of our affordable maintenance plan.
Are there rebates or incentives for installing an energy-efficient tankless water heater in Harrogate?
Yes. Many utility providers in North Yorkshire and the surrounding area offer £150–£300 cash rebates for qualifying high-efficiency gas units. Electric customers may qualify for time-of-use rate discounts. Additionally, the UK Boiler Upgrade Scheme can contribute up to £500 toward low-carbon hot-water technologies. Our team will handle the paperwork to make sure you receive every applicable incentive.